THL Screen Replacement Guide for iPad Pro 10.5" 2017

THL is a technology based enterprise focusing on the research and development, production and sales of mobile screen assembly. THL is committed to providing high-quality mobile phone, screen assembly, professional technical support and responsible after-sales service for global mobile phone accessories wholesalers and mobile phone repair shops.

Buy iPad Pro 10.5" 2017 Display click here: https://www.thldisplay.com/products/copy-of-thl-for-ipad-pro-10-5-2017-display-digitizer-touch-screen-assembly-replacement-kit

Step 1 

Before changing your iPad Pro 10.5 "screen, please turn off your tablet, for obvious safety reasons.

To do this, press the power button located on the upper edge.

Then validate with "Switch off".

 

Step 2

Take a detour to the bathroom to pick up your hair dryer.

Heat the iPad Pro 10.5 screen though for 2 to 3 minutes.

Then insert the spatula between the lower corner of the screen and the frame to create an opening.

Then take over with a pick.

Do not hesitate to heat again if resistance is felt during the next steps!

Step 3

Gently slide the opening pick around the edge of the screen.

Lift it slightly and pull it upwards to free access to the battery connector.

Attention, the screen is always connected by tablecloths!

Step 4

Unscrew the cruciform screw circled in red. (Photo 1)

Then wedge an opening pick under the battery connector so that it no longer makes contact.

There will therefore be no risk of a short circuit during your iPad repair.

Step 5

Tilt the screen vertically to free access to the tablecloths.

Be careful, he is still attached!

Step 6

Unscrew the 2 cruciform screws circled in red. (Photo 1)

Then remove the metal plate using the pliers.

Step 7

Use the nylon spatula to disconnect the first two screens from the screen ...

... As are the two tablecloths hidden under the first ones.

Step 8

You can now separate the screen from the rest of the iPad.

The iPad Pro 10.5 "display is separate and partially disassembled.

We still need to recover the home button in order to preserve Touch ID!

Step 9

Keep the nylon spatula to unlock the first part of the home button cable.

Step 10

Then disconnect the second part.

Heat the tablecloth for a few seconds to facilitate its removal!

Then pass the home button through the hole to separate it from the screen.

Step 11

The iPad Pro 10.5 "screen is completely disassembled. All you have to do is replace your original home button on the new screen.

Follow the advice in this free tutorial to replace the broken screen!

 

We suggest users apply tempered glass film and protect shell for iPad, especially when you have kids who using iPad every day. In that case, it could protect your iPad better and reduce the risk being damaged & reduce the repairing cost.

Thank you for choosing THL.

Enjoy your new screen!

Ipad airIpad pro